Store | Irrigation | Tools
Punch N' Cut
Poly Pipe Punch - Tubing Cutter - Emitter Inserter
This drip tube irrigation tool will help get you through any irrigation project with ease. Use for easy cutting of poly irrigation line or soaker hose, up to .940". A great tool for home gardeners and professional landscapers.
For Poly Punch:
Place tubing crescent against tubing. Apply downward pressure until punch pin pierces tubing. Release. Periodically wipe punch pin with fingers to remove resin build up.
For Emitter/Barb insert:
Insert emitter or barb into upper barb holder. Place emitter or barb against punch hole in tubing. Apply pressure until emitter barb pierces tubing. Remove tool.
For Emitter/Barb Insert with 1/4'" Tubing:
Install emitter with ¼" tubing attached into small crescent slots on bottom of tool. Place shoulder of emitter on outside edge tool with ¼" tubing pressed into smaller crescents. While holding emitter assembly in crescents, place emitter barb against punch hoe in tubing. Apply pressure until emitter barb pierces tubing. Remove tool.
For emitter removal:
Place eased edge on bottom of punch handle against emitter at 45 degree angle. Apply pressure until emitter edge is lifted and seated into crescents. While holding emitter assembly in crescents rotate tool backwards until emitter is removed.
Lightly squeeze handles together while rotating them up and down. As tubing is cut release pressure at the end of cut.
© Sprinkler Depot, all rights reserved 2006-2017